Cowleys Pest Services Before & After Photos

A homeowner in Lincroft had been dealing with mice in their basement, attempting to handle the problem on their own for quite some time. According to the homeowner, they would trap some mice, and drive them 4-5 miles away to a wooded area, and release them. Thereafter, new “replacement” mice would soon appear. This cycle went on for a while. Finally, they decided that their DIY plan of action was not working, and they contacted Cowleys for a permanent resolution of the problem. 

A mouse infestation will not be resolved unless and until their access points into the home are identified and sealed. Without doing this exclusion work, you’ll be in the same situation as these homeowners and dealing with a never-ending stream of mice. Also, I pointed out to the homeowners that, although they had good intentions by not immediately killing the mice, they did not do them any favors by releasing them into a strange area. These relocated mice would likely die because they don’t know where to find adequate food, water, or shelter in their new surroundings, and in their weakened state would likely succumb to predation. 

Upon arrival, after speaking with the homeowners, I grabbed my flashlight and began my inspection. Finding the access points for mice presents a challenge for pest control technicians, especially if they really want to do the job right. Unlike larger wildlife that will use of carve out readily noticeable entry points into the home, mice can get through extremely small cracks and gaps. Because of their fur, mice are even smaller than their appearance. They only need a 1/4" diameter hole (about the size of a dime) to squeeze through. Mice don’t have collarbones. The rule of thumb is that if a mouse is able to poke its little head through a hole, the rest of their body will follow.

Looking for any potential entry points, I thoroughly inspected the basement perimeter, paying careful attention to any gaps around utility pipes or wires going through the foundation wall. These are often the preferred entry route for mice. I found two areas of concern: A PVC pipe discharge line from the sump pump and an outdoor water spigot. Both had sizable gaps that would easily allow rodent entry. 

Before laying out my equipment that I’d be using to control the mice, I first grabbed my hepa-vac to vacuum up all of the rodent droppings. Mouse droppings are toxic, and may contain many dangerous pathogens, including hantavirus. When the droppings dry out, spores can become airborne if the droppings are disturbed, creating a potential health hazard, especially in an enclosed area like a basement. After cleaning the area, I set up some rodent bait stations around the sill plate in the basement, dusted the two openings with a tracking powder, and sealed the holes from the outside with copper mesh. 

The homeowners were relieved that they would no longer be dealing with mice, a problem that had been going on for far too long. 

I was sent to Middletown, NJ with my colleague Alfonso to help a homeowner who had contacted Cowleys after finding mouse droppings in several areas of their home. With any rodent infestation, our priority is finding any actual or potential entry points. Finding mice entry points is a challenge since they can squeeze through the smallest of cracks and crevices. A mouse needs only about a quarter-inch gap to find their way inside your home. If a mouse is able to poke its snout through a hole, the rest of its body will follow. To successfully resolve a mouse infestation, it is critical that these entry points are located and sealed. Failure to do so means that you’ll likely have ongoing problems with these overwintering pests, even if the ones already in your home are eliminated. 

As outdoor temperatures drop, mice, other wildlife, and certain insects will look for harborage in your home to escape the harsh outdoor elements. if there is a weak link for them to gain access inside your home, they’ll find it. Mice commonly look for entry points around the home’s foundation. They’ll enter into the crawl space or basement and then find their way to the living areas of the home when they forage for food and water. One of the most common, and often overlooked, entry points for mice are pipe chases, those spaces where pipes, such as from air conditioning units and the home’s plumbing system, as well as electrical supply lines, are run into the home. Pipe chases often become entry points for overwintering mice and bugs when the original sealant around the pipes starts to become worn and disintegrates, creating a perfect “tunnel” for pests to enter the home. We found several possible entry points around some pipes, and sealed them with chew-proof copper mesh. To reduce the mouse population in and around the home, we set up rodent control bait boxes in the home’s interior as well as the exterior perimeter. Finally, as part of our protocol, we scheduled a two-week follow-up to re-inspect and replenish the bait boxes as necessary. We are confident that with the exclusion and the bait boxes. We’re confident that it won’t take long for the infestation to be resolved, and this homeowner will no longer find droppings and other upsetting signs of mouse activity in his home.

A new resident in Brick, NJ recently purchased a home and wanted Cowleys to replace the insulation in his attic with blown-in cellulose insulation.

When we inspected the attic, there was a ton of old fiberglass insulation pilled on top of one another throughout the attic! Apparently, the previous owner just kept pilling new fiberglass insulation on top of the old ones, thinking that this will properly insulate his attic — it did not!

We removed all the insulation throughout the attic, properly disposed of it, and then vacuumed and disinfected the attic. Afterward, we added approximately 10 inches of TruSoft blown-in cellulose insulation throughout the attic. Our blown-in TruSoft cellulose insulation exceeds the recommended insulation standards and prevents attic air from seeping into the home. TruSoft won't compress, is treated with non-toxic borate (which creates an incredible resistance to mold & pests), has the highest Class-1 fire safety rating, and is eco-friendly!

Now the attic looks more aesthetically pleasing and organized and the homeowner will save a considerable amount of money on his energy bill!

First, we removed all the contaminated insulation and then disinfected the entire attic. Next, we added TruSoft blown-in cellulose insulation, which will fill the attic to its recommended insulation levels. TruSoft blown-in cellulose insulation has a higher R-value than standard fiberglass insulation, has the highest Class-1 fire safety rating, is resistant to mold and pests, and is eco-friendly! Now the attic is transformed from dirty and unhealthy to a clean and energy-saving one!

After spotting a squirrel roaming around in his attic, this homeowner in Brick, NJ immediately called Little Rascals for help. After a thorough investigation, we determined that the squirrels were using an exposed exhaust vent in the attic to infest the home.

We temporarily enclosed the area with hardware cloth, installed a one-way device in front of the exhaust vent, and set up several baited traps nearby. The one-way will allow the squirrel to safely leave the attic, but prevent it from getting back in. A short while later, we successfully retrieved the squirrel and relocated it to a new, humane location. 

Additionally, we disinfected that attic and installed a DryerWallVent®. The DryerWallVent® is made out of heavy-duty galvanized steel and its large opening and angled damper provide maximum airflow efficiency for safe venting. Integrated magnets keep the damper closed when not in use, preventing squirrels, birds, and all nuisance wildlife from infesting the home.